Download Machine software using a USB stick

Applies to Maximator UK machines with B&R controllers.

In most cases, software updates will be made available on a USB stick. To use one of these to dowload software onto a machine, follow the steps below.

How to download software to a Maximator UK machine using a USB stick.

For an RM350 unit:

Make sure that the software is the right version for your machine.

Insert the USB stick into a USB port on the controller

Turn on the power (if it is already on, turn off and then on again)

Wait a few minutes until the normal home screen appears.

Remove the USB stick (no need to turn off the power).

IMPORTANT: You must follow the instructions at the bottom of the page and get an unlock code for this software to run.

For VP Series machines, PRESUS C and HIMAX:

Make sure that the software is the right version for your machine.

Insert the USB stick into a USB port on the controller

It is necessary to enter boot mode on the controller (see picture). Please read the instructions and follow carefully:

To enter boot mode:

  • Press the reset button and let go. The "R" light goes red

  • Within 2 seconds, press and hold the reset button. Hold until the "R" light goes out.

  • Release the button

  • The controller is now in boot mode and will load software from a USB stick if inserted.

Wait for the "R" LED on the controller to be constantly lit green before taking out the USB stick. The update will take a few minutes. Note that if you are updating a HIMAX unit, and the Stepper motor driver card requires a firmware update, it can take 15 minutes. This is indicated by a double flash of the "R" light on the CP1301 and a double flashing of the "r" light on the Stepper motor driver (SM) card.

Some machines require you to enter a code after an update. This is to make sure that only equipment purchased from Maximator UK is run with our software. If you see a message asking you to enter a code, go to maximator.co.uk/unlock and enter the full serial number of the controller or screen to obtain your code. Enter this on the machine and the software will run normally. It is only necessary to do this once after an update.