How to adjust Presus C Settings

You will need:

• A PC with an Ethernet connection

• An Ethernet patch cable (CAT 5 or CAT 6)

• VNC viewer software (free download here)

Method

• Install VNC Viewer on the PC. Follow the instructions on the web site

• Setup your ethernet connection with a fixed IP address of 10.44.10.100

  • Go into sharing and network centre

  • Select the ethernet connection and click Properties

  • Double click on the Internet Protocol Version 4(TCP/IPv4) item

  • Check "Use the following IP address"

  • Enter 10.44.10.100 as the IP address and 255.255.255.0 as the Subnet mask

  • Click OK, then OK, then Close. 

  • Check your IP address is correct (Click "Details")

• Connect the patch cable from the PC to the PLC in the control panel

• Run VNC viewer.

• Make a new connection

  • IP address 10.44.10.240

  • password = "c" (lower case letter C)

• You can change parameters here. See picture

Caution

Do not change settings unless you understand the consequences.